Used 2011 Roadtec SB2500D Shuttle Buggy – Material Transfer Vehicle
Unit has 8515 hours
Available on request
As Is-Where Is (Buggy was completely gone over and fully serviced in winter 2019-2020)
FOB Truro NS
CAT® C9-300 HP, Tier llI, 6-cylinder diesel engine, 300 HP (224 kw) @ 2,200 rpm. Engine instrumentation includes tach/hour meter, oil pressure, voltage and emergency shutdown system. Easy access to oil cooler/radiator.
Operator positions on both sides. Control panel pivots for use from either station allowing for same-lane or adjacent-lane operation from either side. One-piece hydraulically-raisable hood allows easy access to engine, pumps and motors. Inside turning radius 26’6″ (8.1 m).
All hydrostatic for continuously variable speed control with two speed ranges. Electric-over-hydraulic shift between working and transport ranges. Maximum speed (working range) 3.0 mph (4.8 kph). Maximum speed (travel range) 9 mph (14.5 kph).
Large, high-flotation – 21:00 x 25″ (53.3 m x 635 mm).
Standard system includes heavy-duty alternator, battery, and circuit breaker protection of all systems.
FUME EXTRACTION SYSTEM:
Two blowers. Fold-down 10″ (254 mm) exhaust pipes.
SLAT CONVEYORS TRUCK UNLOADING (C-1):
High-capacity truck unloading system with low deck height, 9’2″ (2.8 m) truck opening and 22″ (559 mm) o.d. x 8″ (203 mm) deep, 27% chrome-iron cast, segmented converging auger for quick material flow. Conveyor has weld-on flights 5/8″ (16 mm) thick, 5.5″ (140 mm) wide x 57″ (1,448 mm) long. Ni-Hard liner plates are removable. Power dump front hopper has a vibrator on the bottom that helps keep material moving. Adjustable push roller is standard. Conveyor capacity
is rated at 1,000 TPH (907 MTPH).
SURGE BIN (C-2):
Unloads the surge bin with a multi-pitch 22″ (559 mm) o.d. x 8″ (203 mm) deep, 27% chrome-iron cast, segmented anti-segregation auger in the hopper. Conveyor system has weld-on flights 5/8″ (16 mm) thick, 7″ (178 mm) wide x dual 16″ (406 mm) long. Liner plates are Ni-Hard and removable. Conveyor capacity is 600 TPH (544 MTPH).
PAVER LOADING (C-3):
Conveyor swings 55 degrees to either side of center. Maximum conveyor discharge height is 12′ 6″ (3.8 m) from ground level. Conveyor flights welded to the chain are 1/2″ (12.7 mm) thick, 3″ (76.2 mm) wide and 30″ (762 mm) long. Conveyor has bolted 1/2″ (12.7 mm) 500 Brinell replaceable floor plates. C-2 and C-3 conveyors have on/off controls that are interlocked. Conveyor capacity is 600 TPH (544 MTPH).
Fuel tank…………………………………….140 gal (529 L)
Hopper……………………………………25 tons (22.7 MT)
material………………..120 lbs/cu ft (1,922 kg/cu m)